Robot Servo Pack - Blue
MAK045-PNote:
Makeblock Socket Cap Screw will be replaced by Button Head Socket Cap Screw gradually, and the tool HEX Screwdriver 3mm will be replaced by HEX Screwdriver 2.5mm.
Button Head Socket Cap Screw is a new kind of Socket Cap Screw, it has smaller head that can solve most problem of interfere with other components.
Description:
This Kit contains a Makeblock high torque(15kg.cm) digital servo and 2 servo bracket, with these bracket, it's easy to build a joint for a robot, also there are a lot of ways to conenct the servo with other Makeblock Parts.
Specification:
| Mechanical Specification | |
| Size | 40 × 20 × 41mm |
| Weight | 75g |
| Gear type | 5 metal gear |
| Limit angle | 210°±5° |
| Bearing | 2 x Bearing |
| Horn gear spline | Φ8mm35T |
| Horn type | Plastic, POM |
| Case | Aluminum alloy+Engineering plastics |
| Connector wire | 230mm±5mm |
| Motor | Coreless Motor |
| Splash water resistance | No |
| Electrical Specification | |
| Operat voltage | 6.0V |
| Idle current | 8mA |
| No load speed | 0.19sec/60° |
| Runnig current | 450mA |
| Peak stall torque | 16.5kg.cm |
| Stall current | 2500mA |
| Control Specification | |
| Command signal | Pulse width modification |
| Amplifier type | Digital controller |
| Pulse width range | 500-2500usec |
| Neutral position | 1500usec |
| Running degree | 180°±3°(when 1000～2000usec) |
| Dead band width | 5 usec |
| Rotating direction | Counterclockwise (when 1000～1500usec) |
Part List:
| 1 x | MECDS-150 Servo Motor |
| 2 x | MECDS-150 Servo Bracket |
| 8 x | Socket Cap Screw M4x8 |
| 8 x | Plastic Ring 4x7x2mm |
OPEN LAB
 |
PAN/TILT SERVO PLATFORMPan/Tilt Servo Platform is based on a big metal servo with two degrees of freedom – vertical and level. You can install a camera on the platform for image monitoring and image recognition for location tracking. Or you can install an infrared sensor or ultrasonic sensor to make a detector which enables robots to avoid obstacles. |
||
|
|
|||
 |
SCARA ARM FOR THE TOWER OF HANOITo create a scara arm with two big metal servos and to make its end move horizontally. Just think it over, what can we do with scara arm? As you see, the vertically moving scara arm can easily catch and move the Tower of Hanoi. I guess you must be surprised by its continuous and smooth actions, aren't you? |
||